How to Winterize a Camper: Step-by-Step Guide for Freezing Weather

To winterize a camper, drain the fresh, gray and black tanks and the water heater, bypass the water heater, run non-toxic RV antifreeze through every faucet and drain until it shows up pink, and then protect the batteries, tires and interior. Do it before the first night at or below 32°F. Travel trailers, fifth wheels and motorhomes follow the same steps, but valve locations differ, so keep your owner’s manual open at the plumbing diagram.

Why winterizing matters

Water expands when it freezes. If any is left in the lines, pump, toilet valve or fittings, the ice can split a fitting or crack the pump housing, and you may not find out until the thaw in spring.

Three ideas cause most of the damage:

  • “Draining the fresh tank is enough.” Water also sits in lines, elbows and fittings.
  • “Indoor storage means the rig is safe.” Only a heated space does. RV.com notes that garages and barns can drop below freezing.
  • “Only northern states need this.” Cold snaps reach the South, though RV.com says that in warm states you may not need a full winterization and should still inspect the roof and seals, clean and drain the tanks, and look after the batteries.

When to winterize

RJourney, an RV park operator, advises winterizing before the first night of sustained temperatures below freezing. By its account a brief dip to 30°F won’t hurt a camper that still holds the day’s warmth, while a night in the low 20s will. The plumbing runs through underbelly spaces that freeze before the cabin does, so the lines in the floor are what you’re really forecasting. Frost on the roof in the morning, lows that stay below freezing for hours, or plans to park the rig for more than a couple of weeks all say it’s time.

Camping through the winter in the rig is a different job, covered near the end.

What you need

  • RV antifreeze, the pink non-toxic propylene glycol kind. Boondock or Bust, which compiles guidance from several RV makers, says to plan on 2 to 6 gallons depending on the rig: Camping World puts most RVs at 2 to 4 gallons and Keystone RV at 4 to 6.
  • A water pump converter kit, or a hand pump
  • A water heater bypass kit, if the rig has no built-in bypass
  • The right socket for the water heater drain plug or anode rod
  • A tank flush wand or a built-in flush connection for the black tank
  • For the air method: an air compressor with a regulator and a blow-out plug that fits the city water inlet

Lay everything out before you start, so you aren’t walking in and out with cold hands.

Automotive antifreeze is made for engines and is toxic, so it never goes into a drinking water system. Buy only antifreeze labeled for RV or marine potable systems, and read the label.

The antifreeze method, step by step

  1. Drain the tanks. Empty the black tank first, then the gray, at a dump station. Flush the black tank until the water runs clear. RJourney warns that waste left in the tanks over winter dries into a layer that spring flushing can’t fully remove.
  2. Drain the fresh water tank and open the low-point drains. Turn off the pump, disconnect city water and open the fresh tank drain. Then open the low-point drains under the rig, typically one hot and one cold. Open every faucet, hot and cold, plus the outdoor shower, to let air in.
  3. Drain the water heater. Turn it off, gas and electric, and let the water cool. Then remove the drain plug or anode rod and open the pressure relief valve. Leave the plug out until the end.
  4. Bypass the water heater. Set the bypass valves so antifreeze skips the tank. A water heater holds 6 to 10 gallons, and without the bypass the tank swallows around 6 gallons of antifreeze before any reaches the faucets.
  5. Bypass or remove water filters. Inline and under-sink filters can be damaged by antifreeze. Remove the cartridge or bypass the filter, depending on the model.
  6. Close the low points. Once the fresh tank has drained, put the low-point drain caps back and close the faucets.
  7. Connect the pump. Use a converter kit on the pump inlet, or a hand pump at the city water inlet, with the suction end in a jug of RV antifreeze.
  8. Run antifreeze through the lines. Turn on the pump and open each faucet one at a time, cold side first and then hot, until it runs solid pink. Cover the kitchen, bathroom, indoor and outdoor showers, and flush the toilet until pink appears.
  9. Protect the P-traps. RV.com says to pour about a cup of antifreeze down every drain and into the toilet bowl, then flush once to protect the valve seal.
  10. Finish up. Put the water heater plug back in and label the bypass valve so nobody fires up the heater with antifreeze in the tank. The antifreeze stays in the lines until spring.

Ice makers, washers and tankless water heaters have their own procedures. Boondock or Bust, quoting Keystone RV, says not to put antifreeze in an ice maker line at all; drain it with the other water lines.

The compressed air method

Some owners blow the water out of the lines with air instead of filling them with antifreeze.

  1. Drain the tanks and the water heater, and set the bypass.
  2. Put a blow-out plug on the city water inlet and connect an air compressor with a regulator.
  3. Set the pressure to 30 to 40 psi. RV.com and RJourney both give that range, and RV.com warns against going higher because it risks damaging the lines.
  4. Open one faucet at a time, hot and cold, until only air comes out. Start at the highest point and work down. Do the toilet and outdoor shower too.
  5. Add a little antifreeze to each drain and the toilet bowl afterward. Air can leave water in the low spots and traps.

The rest of the rig

Plumbing is only part of the job.

Batteries. Charge them fully, then disconnect them. Pull them for a long stay if you can, store them somewhere above freezing and put them on a maintainer. Lithium batteries shouldn’t be charged below 32°F, so check your battery’s specs before leaving one connected to solar.

Propane. Close the tank valves for storage.

Tires. Inflate to the sidewall maximum, since pressure drops as temperatures fall, and cover the tires if the rig sits outside. A board or mat underneath keeps them off cold, damp ground.

Roof and seams. Walk the roof and check every seam and sealant bead. Snow sitting on a failed seal becomes a ceiling stain in spring.

Interior. Empty the fridge, wipe it down and prop the doors open to prevent mold. Take out food, cleaners, spray cans and water bottles. Set out moisture absorbers, and plug steel wool into any gap where a mouse could follow the plumbing in. RJourney says mice do more winter damage to stored campers than ice does.

Cover. Outdoors, a breathable fitted cover is better than a blue tarp, which traps moisture and can rub the paint.

If you plan to live in the camper through winter

Winterizing is for rigs that sit empty. A rig that stays in use needs a different setup. RJourney lists a heated water hose, holding-tank heat pads, and skirting around the base to stop wind from stripping heat off the underbelly, and calls skirting the single biggest upgrade for winter livability.

Carbon monoxide and fire risk go up when a rig is sealed against the cold. Test the CO alarm and smoke alarm, and never run a fuel-burning heater in an unvented space.

Mistakes that cost a spring repair

  • Skipping the water heater bypass, which burns through antifreeze and leaves the tank to cause trouble later
  • Pouring automotive antifreeze into a potable system
  • Overlooking the outdoor shower, ice maker or washer hookup
  • Pumping antifreeze into the fresh tank when a converter kit would send it straight to the pump
  • Going past the pressure limit with the air compressor
  • Leaving the valves unlabeled, which makes spring startup guesswork

Spring: de-winterizing

Close the low-point drains, put the water heater plug back and set the bypass valves to normal. Flush the antifreeze out of the fresh water system before you drink from it, repeating the flush a few times. Sanitize the system if your manual calls for it, and check for leaks with the pump on before the first trip.

Frequently asked questions

How strong should RV antifreeze be?

Boondock or Bust says a system winterized properly with -50 RV antifreeze should show a freeze point around +10°F when you test it, which indicates burst protection to -50°F.

Can I use antifreeze in the ice maker line?

No. Drain the line with the rest of the water lines, as the Keystone RV guidance quoted above says. For a washer hookup or a tankless water heater, follow the manual for that appliance.

What should I wear when emptying the tanks?

Waterproof gloves at the least. Boondock or Bust points to general CDC guidance for people handling sewage: goggles, a face mask or splash-proof face shield, liquid-repellent coveralls, waterproof gloves and rubber boots, then soap and water on your hands right after.

How long does RV antifreeze last?

RV.com says an unopened jug lasts several years on the shelf, and that antifreeze in your system is meant to protect for one winter season.

Can I stay in the camper while it's winterized?

The water system is shut off in a winterized rig, so a short winter trip means hauling in water and using a campground bathhouse. If you plan to stay a while, keep the plumbing running with heat instead.

Before you drive home, take a photo of the bypass valve positions and the low-point drains with the caps off. In spring, those photos show you exactly what to put back.

About the author

Vu Tuan Tran is a passionate camping enthusiast with over 20 years of experience. He has camped in all kinds of terrain and is an expert in setting up tents, cooking over campfires, and finding the best spots to stargaze. He is also a skilled photographer who loves capturing the beauty of the natural world. If you are looking for a camping partner who is knowledgeable, experienced, and fun-loving, then Vu is your guy.